How should I prep my van before dropping it off for wrapping?+
Wash the exterior thoroughly using a pressure washer the day before your appointment, avoiding any waxes, polishes, or silicone coatings. Panels must be free of road tar, mud, and grease. The specialist will carry out an industrial solvent degrease right before laying the vinyl.
What is the difference between polymeric and cast vinyl?+
Polymeric vinyl is suitable for flat surfaces or mild, shallow curves like van side panels. Cast vinyl is thinner, highly pliable, and has no material memory. It is essential for deep swage lines, bumpers, and full car wrapping because it does not lift or shrink when exposed to outdoor heat.
What does French law say about tinted front windows?+
The French highway code requires a minimum 70% light transmission on front side windows. The installer fits approved films meeting this exact legal threshold. In contrast, rear side windows and rear windscreens carry no darkness restrictions, provided the vehicle has both left and right exterior wing mirrors.
How long will my vehicle be kept in the workshop?+
Turnaround depends on the scope of the project. Fitting basic lettering or cut logos usually takes half a day. A partial wrap or front PPF package requires one to two days. A full wrap takes several days to allow for partial dismantling, thorough degreasing, edge finishing, and adhesive curing.
Does a vinyl wrap protect the original vehicle paint?+
Yes, high‑grade vinyl shields original factory paint from UV sun fading, stone abrasions, and superficial scuffs. When properly removed by a trained professional, the underlying paint retains its gloss without lacquer damage or adhesive residue.
How do I wash a vehicle with commercial vinyl branding?+
Hand washing with a soft sponge and neutral car shampoo is best. Pressure washing is fine if you keep the lance at a sensible distance and spray straight on at a right angle. Never aim the high‑pressure water jet directly at decal edges or seam joins.
What design files do I need to send to start production?+
Supply your logos and layout files in vector format (such as PDF, EPS, or AI) with all text converted to curves and specified colour values. The pro rescales these graphics against precise manufacturer templates. If you only have raster images, extra artwork redraw charges may apply.
Can the signwriter install the vinyl graphics at my premises?+
On‑site installation is only possible for basic cut lettering or flat decals, provided you have a clean, draught‑free, and heated indoor bay. Full wraps and paint protection films must always be applied in the specialist workshop to avoid airborne dust settling under the vinyl.
How much does Kelki cost?+
Nothing: Kelki is 100% free for you. Describe what you need in a few clicks, a professional in your area calls you back and tells you their price. The service is funded by the professionals.